Disk Read-Write Module USB Flash Disk For Arduino CH376S
Disk Read-Write Module USB Flash Disk In Pakistan
USB interface in the current electronic products accounted for a very large share of the microcontroller with USB interface communication direction of one of the most popular microcomputer application master chip module using the CH376S, CH376S is a USB bus interface chip to support USB-The hOST and USB-DEVICE/SLAVE equipment the way. Locally, CH376S with the 8-bit data bus and read, write, chip select control lines and interrupt output can be easily attached to the system bus of the microcontroller/DSP/MCU/MPU controller. USB host mode, CH375 also provides serial communication via serial input, serial output, and interrupt output monolithic/DSP/MCU/MPU connected.
This product is no longer in stock
DRV8825 Stepper Motor Driver
MAXIMUM CURRENT =2.2AMP.
This breakout board for TI’s DRV8825 micro stepping bipolar stepper motor driver features adjustable current limiting, over-current and over-temperature protection, and six micro step resolutions (down to 1/32-step). It operates from 8.2 V to 45 V and can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (rated for up to 2.2 A per coil with sufficient additional cooling). The driver has a pinout and interface that are nearly identical to those of our A4988 stepper motor driver carriers, so it can be used as a higher-performance drop-in replacement for those boards in many applications.
ESP8266 12E WIFI Module
ESP8266 12E WIFI Module In Pakistan
- Added six I/O serial and six SPI serial
- support wireless 802.11 b/g/n standard
- support the STA/AP/STA + AP three work modes
- support rich Socket the AT command
- support UART/GPIO data communication interface
- support Smart Link intelligent networking
RAMPS 1.4 / RepRap GLCD Shield Arduino Mega
RAMPS 1.4 / RepRap GLCD Shield Arduino Mega In Pakistan
This Smart Controller contains an SD-Card reader, a rotary encoder, and a 128×64 LCD display. You can easily connect it to your Ramps board using the “smart adapter” included. After connecting this panel to your Ramps you don’t need your pc anymore, the Smart Controller supplies power to your SD card. Furthermore, all actions like calibration, axes movements can be done by just using the rotary encoder on the Smart Controller. Print your 3D designs without PC, just with a g-code design stored on the SD card.